63-72 C10 AirBag Brackets Combo

Our 63-72 C10 airbag brackets combo comes with all the brackets you need to install airbags in the front and rear of your 63-72 C10 (for trucks without leaf springs in rear).   Buying the combo will save you money and make it easier to install airbags on your classic C10!

The front cups and brackets in this combo kit allow you to install air bags to your front suspension and get low!  What makes this kit unique is that these upper plates bolt directly to the cross-member where the OE springs originally sat. Hold/clamp the upper plate to your frame, an mark the holes with a marking pen or chalk.  After marking the holes,  you drill the holes out.  This is where the plate will bolt to the frame.  Next run your airline to the bag and then bolt the bag to the plate.  To finish the install, simply bolt the plate/bag assembly to the  frame. Then install lower bag cups which bolt to the bottom of the bags and sit in the lower control arm.  Its that easy!  These are constructed of 1/4 inch steel and are laser cut to be very precise.  The mounting holes are cut out to allow you to mount these to any manufacturer's air bags.   

The rear c10 airbag brackets (cups and plates) allow you to install air bags to the rear of your trailing arm suspension and plant the rear of your c10 on the ground!  What makes this kit unique is that the rear upper cups bolt directly to the where the original coil springs sat. The center stud in the upper cups allow you to bolt them in position.  Simply bolt the upper cup to the top of your airbag(after installing your air fitting) and then mount the assembly.  The circular plates are the lower bag mounts and these sit on top the rear trailing arms where the factory spring oroginally sat. Push the bolt up through the hole in the trailing arm, through the lower plate, and then into the threaded hole in the bottom of the air bag.  TALK ABOUT SIMPLE!