1/2 inch Air Fitting Kit
(Front and Rear Control)
Only $159.99 from us!
Scroll down for more info!
Our 1/2 inch Front and Back Air Fitting kit was designed to make
the plumbing of
suspension system simple
and easy to install
. Not only that, but
also offer you the highest quality air fittings in the country at an
incredible price! These air fittings are all dot approved and have very high
pressure ratings (up to 1000psi!)
This kit is set up to use 1/2" dot air line and 1/2" valves.
This kit will allow you to control your front air
together, and your rear air bags together
1/2 inch valves are required
for this set up. Keep in mind that this setup is fast
your custom car or truck will lift and or lower very fast when using
your air suspension.
Installation is very
easy. Since Loctite Thread Sealant is already applied, NO
TEFLON TAPE IS NEEDED! After you screw and tighten the
posistion, simply plug in your air line and you are all set for a leak
will want to
use our fittings to benefit
from the following features:
- All Metal
Construction-not plastic like other companies sell
- Meets all requirements for Federal DOT
(Department of Transportation)
- Teflon tape not required
Temperature Range: -40°F to 200°F
Working pressure 0-1000psi!
Electroless Nickel Plated Brass
Body with a low pressurure BUNA-N O-Ring
For use with DOT approved Nylon
Compressed Air Applications
Suggested retail price
Price is only $159.99
here to return to our air fitting kit page for other sizes and